Filter
Top Products
VALET MODE
You can prevent your security system from automatically arming and triggering by using Valet
Mode. This is very useful when washing the vehicle or having it serviced. In Valet Mode, the
security system will not arm, even with the remote transmitter, but all convenience functions
(door locks, trunk release, etc.) will continue to work normally.
To enter or exit Valet Mode:
1. Turn the ignition on.
1. Turn the ignition off.
1. Press and release the Valet button within 10 seconds.
The status LED will light solidly if you are entering Valet
Mode, and it will go out if you are exiting Valet Mode.
The remote will respond with 5-flashes of the
icon and 2 beeps on entering or exiting Valet
®
Mode.
To enter or exit Valet Mode using the transmitter:
1. Open any vehicle door.
Quickly press the following buttons in the sequence indicated.
2. Press
.
3. Press
.
4. Press
again.
ONE-TIME BYPASS
This feature stops the alarm from arming or activating any outputs that are programmed to
activate when the alarm is armed.
One-time bypass will defeat the following actions:
Passive arming: If programmed ON the alarm will not arm itself.
If the remote is used to arm the alarm after exiting the vehicle:
Window roll up: If programmed ON this output will not activate.
Linked Auxiliary Outputs: If programmed to activate on arm, they will not activate.
To activate one-time bypass:
1. After parking turn the ignition off.
12 © 2006 Astroflex Electronics - All rights reserved