Filter
Top Products
2. If a switch (Zone 1, 3, 5, or 6) triggered the system, the remote will emit 4 quick beeps and
the LCD screen will indicate which switch (5-flashes) tripped the alarm.
3. If the system was triggered so many times that NPC is active the remote will emit the above
notifications with 5 beeps instead of 4.
DISARMING WITHOUT A TRANSMITTER
This feature allows you to disarm the security system without the remote transmitter should it be
lost or damaged. In order to disarm the system without a remote transmitter, you must have the
vehicle’s ignition key and know where the Valet button is located. Be sure to check with the
installer for the location and the number of presses of the Valet button required to disarm the
system.
To disarm the security system, turn the ignition to
the ON position. Press the Valet button the preset
number of times (one to five times) within 15 seconds.
After five seconds the system will disarm. If the system
does not disarm, you may have waited too long; turn
the ignition off and on and try again.
Location of Valet Button
Number of Pulses
IMPORTANT! The unit can be programmed to respond to one
to five pulses of the Valet button for the disarm function.
Be sure to check with the installer for the desired programming.
The LCD remote will indicate disarm notification with 4 quick beeps and 5 flashes of the
and
triggered zone icons.
DOME LIGHT CONTROL
Security only
The dome light activates for 30-seconds after the system is disarmed.
Ignition controlled
The dome light activates for 30-seconds after the ignition is turned Off.
Door controlled
The dome light activates for 30-seconds after the system sees a door has closed. (If door was held
open for longer than 3 minutes the dome light will not illuminate.)
Full
The dome light activates for 30-seconds after seeing door closure, ignition, or security disarm.
10 © 2006 Astroflex Electronics - All rights reserved