Filter
Top Products
Important information
Congratulations on the purchase of your state-of-the-art vehicle security system. This system has
been designed to provide years of trouble-free operation. Due to the complexity of this system, it
must be installed by an authorized dealer only. Installation of this product by anyone other than
an authorized dealer voids the warranty. This owner’s guide should help you to get the most out
of your system. Please take the time to read it prior to using the system.
SYSTEM MAINTENANCE
This system needs no specific maintenance beyond remote controls battery
replacement.
The 4-button remote is powered by a 1.5V AAA battery.
FULL
CHARGE
NEED
REPLACEMENT
EMPTY
The Battery Level indicator has four level indicators that serve as a visual
indication of battery charge. When the battery reaches a low charge level
that requires replacement, the remote control will generate a single
notification chirp, and the Battery Level indicator will flash continuously.
Battery Replacement
Gently pull the end of the battery door away from the top of the remote control then slide the
door up to expose the battery and remove the expired battery. Place the new battery into the
remote control observing the correct polarity. When power is returned the remote control will
display all icons in the LCD and generate all beeper tones once. Press any button on the remote to
terminate the beeper tone review.
The 3-button remote is powered by a small, lightweight 3-volt lithium battery (CR2032) that will
last approximately one year under normal use. When the battery begins to weaken, operating
range will be reduced and the LED on the remote will dim.
Battery replacement
Remove the screw on the back of the remote, gently open the casing to expose the battery and
remove the expired battery. Place the new battery into the remote control observing the correct
polarity.
FCC/ID NOTICE
Directed Electronics, Inc
This device complies with Part 15 of FCC rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
This device must accept any interference received,
including interference that may cause undesirable
operation. Changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate this device.
Tested to comply
with FCC standards
2 © 2006 Astroflex Electronics - All rights reserved