Filter
Top Products
High frequency
Your system transmits and receives at 434 MHz. This provides a cleaner spectrum with less
interference and a more stable signal. Enjoy a phenomenal increase in range – even in areas with
high radio interference.
Owner recognition
Using a hand-held programming tool, your dealer can program many of the system settings. The
programmer makes it possible to program different settings for each transmitter that is used with
the system. Then, whenever a specific transmitter is used, the system will recall the settings
assigned to that transmitter. Owner Recognition lets up to four users of the system have different
settings that meet their specific needs. It is almost like having four separate alarms in your vehicle,
one for each user.
NOTE: Owner Recognition cannot be programmed
without a programming tool and the necessary software.
Check with your dealer for more information.
Rapid resume logic
This system will store its current state to non-volatile memory. If power is lost and then
reconnected, the system will recall the stored state from memory. This means if the unit is in Valet
Mode and the battery is disconnected for any reason, such as servicing the car, when the battery
is reconnected the unit will still be in Valet Mode. This applies to all states of the system including
arm, disarm, VRS
®
, and Valet Mode.
Power saver mode
Your system will automatically enter Power Saver Mode while armed or in Valet
®
Mode, after a
period of time in which no operation has been performed. This lowers the current draw to the
vehicle’s battery. Power Saver Mode takes over under the following conditions:
Power Saver when the system is armed: After the system has been armed for 24 hours, the
in-vehicle LED will flash at half its normal rate, decreasing the system's current draw.
Power Saver in Valet
®
Mode: When the system enters Valet
®
Mode the in-vehicle LED
illuminates steadily. If the vehicle is not used (ignition is not turned on) for a period of one
hour while the system is in Valet
®
Mode, the LED will shut off. If the system remains in Valet
®
Mode, the LED will come back on the next time the ignition is turned on and then back off.
19 © 2006 Astroflex Electronics - All rights reserved