Filter
Top Products
Moducon Belt Conveyor UGR004/1200
5-4 MAINTENANCE
Be sure the main power is disconnected.
Always disconnect and lock out the main power source
before servicing the unit.
Inspect all wires and connections.
Look for loose wires, burned contacts, and signs of over-
heated wires. Have a qualified electrician make any nec-
essary repairs or replacements.
Inspect the exterior power cord.
The cord should not be crimped, exposed, or rubbing
against the frame. If the cable runs along the floor, make
sure it is not positioned where it could rest in pooling
water or could be run over and cut by wheels or casters.
CHECKING
ELECTRICAL
CONNECTIONS
1
2
3
WARNING: Improper installation,
operation, or servicing may result in
equipment damage or personal
injury.
This equipment should be installed, adjusted,
and serviced only by qualified technical per-
sonnel who are familiar with the construction,
operation, and potential hazards of this type of
machine.
All wiring, disconnects, and fuses should be
installed and maintained by qualified electrical
technicians in accordance with electrical codes
in your region.
WARNING: Disconnect power
sources to prevent injury from
unexpected energization or startup.
To prevent possible injury from unexpected
startup, always disconnect and lock out the
main power source before performing mainte-
nance or troubleshooting on this product.
WARNING: Electrical Shock Hazard
This device must be properly grounded.
Improper grounding can result in severe
personal injury and erratic machine operation.
Do not operate the equipment at power levels
other than what is specified on the machine
serial plate.