Filter
Top Products
Moducon Belt Conveyor UGR004/1200
3-6 INSTALLATION
If the conveyor is not working properly at any time, slide the
control button to the Standby position immediately and unplug
the conveyor from the main power source. Refer to the
T
ROUBLESHOOTING
section of this User Guide.
If you do not encounter any problems during testing, proceed
to the
OPERATION
section.
ADJUSTING THE
CONVEYOR
To adjust the speed of the conveyor belt:
Turn the speed control dial to Low.
If the speed is not set on Low, turn the dial counterclock-
wise as far as possible to the Low position. The belt
should not be moving.
Slide the control button to the Run position.
The conveyor belt begins to move.
Adjust the speed of the belt by turning the dial
clockwise until the belt is moving at the speed you want.
2
3
1
Dial
Turn clockwise to increase
belt speed. Turn counterclock-
wise to slow belt speed.
Control button