A SERVICE OF

logo

Screen Descriptions 125
Screen Descriptions
Unit of Measure Screen
The Unit of Measure screen, Figure 4.18, lets you select the preferred unit of measure in
which the antenna height values are to be entered in the
Point Attribute screen. The selection
also defines the unit of measure used to display thresholds in the Observation Timer parameter
found on the
Survey Status screen. The Unit of Measure Screen, accessed by selecting Units
in the
Survey Menu, displays the currently selected unit of measure. Table 4.14 describes the
selectable parameters.
Note: The setting of Unit of Measure is saved after a power cycle.
Figure 4.18 Unit of Measure Screen
Table 4.14 Unit of Measure Screen Parameters
Parameter Description
Units As shown in the figure, this is the currently selected unit of measure. Pressing ENTER will
produce a selection list of the available units of measure: Meters, International Feet, U.S. Feet.
Save Saves setting.