Screen Descriptions 119
Screen Descriptions
Init Mode Screen
The Init Mode screen, Figure 4.12, is accessed from the Point Attribute screen when the
Initialize field is highlighted and the
Enter key is pressed.
The
Init Mode screen lets you select a type of point initialization. The options include
<None>, Bar, and Known. Table 4.9 describes the screen parameters.
Figure 4.12 Init Mode Screen
Table 4.9 Init Mode Screen Parameters
Parameter Description
<None> Sets the initialization tag for the point occupation to none. The point will not be listed
as an initialization point.
Bar Sets the initialization tag for the point occupation to kinematic bar. The post
processing software will detect the point as an initialization point.
Known Sets the initialization tag for the point occupation to known point. The post processing
software will detect the point as an initialization point. Bar and Known are available
during a stop-and-go and kinematic data collection mode. Known is available after a
point has been tagged as Control Point and logged in stop-and-go mode of operation.
If returning to a known point that has not previously been set as a control point, simply
use the same site ID and set it as a control point when the re-occupation takes place.
Save Saves settings.
Note: Known is not available unless at least one point has been tagged as Control and logged. Also, Known
is not available if all site IDs from the Known point table are deleted.
