98 Promark2 User’s Guide
Refer to the description of the
Point Attribute- Kinematic screen, page 116, for
further details regarding this screen.
Note: The
Point Attribute – Kinematic screen allows you to set the Time on Site
field when the
Initialize field is set to Bar or Known Point. Otherwise the Time on
Site
field is not available.
Note: The
Known Point option is only available after a point has been tagged as
Control in stop-and-go mode. The Known Point list needs to be created in stop-and-
go mode, and then this information is available in kinematic rover mode.
6. From the
Survey Menu, select Recording Interval (see also page 120). Set the
recording interval to 1 or 2 seconds, and be sure to match this interval in the Rover
receiver.
7. From the
Survey Menu, select Antenna. Set the antenna height parameters for this
point. Select
Slant if you are measuring the antenna height to the outside edge of the
GPS antenna, or
Vertical if you are measuring the antenna height to the bottom of the
GPS antenna. Enter the measured antenna height value. Change the units of measure
by selecting
Units from the Survey Menu (page 110).
8. From the
Survey Menu, select File Manager. Delete old data files if more memory
is required to complete this observation session.
With
File Manager highlighted, press ENTER to bring up the File Manager screen,
Figure 3.61 Recording Interval Screen
