114 ProMark2 User’s Guide
Point Attribute - Stop-and-go Screen
The Point Attribute Stop-and-go screen, Figure 4.8, lets you enter and store point attribute
information when in stop-and-go mode. Table 4.5 describes the screen parameters.
Figure 4.8 Point Attribute - Stop-and-go Screen
Table 4.5 Point Attribute - Stop-and-go Parameters
Parameter Description
Site ID Lets you enter a 4-character alphanumeric site ID. Valid characters are all characters
except for space, < > : and \. If an illegal character is entered, it will automatically be
replaced by – (dash). The default entry is “0001”. Entering “1” will display “0001”.
Time on site Lets you enter the occupation time on site in seconds. The receiver will count down
the seconds during data collection. The valid range is 1 – 9999. The default setting is
10 seconds. If initializing on a bar the default setting is 300 seconds.
Note: If time on site is less then the recording interval, the value is not accepted and
the time on site field will display the recording interval value.
Site Description Calls the Site Description screen where you can select a descriptor from the descriptor
list, enter a new descriptor of up to 20 characters, edit a descriptor, and delete a
descriptor. The default entry is blank.
Initialize Calls the Init Mode screen where you can set the occupation as an initialization point
on an initializer bar or a known point. Set to <None> if no initialization is desired.
The default setting is None.
