Screen Descriptions 117
Screen Descriptions
Site ID Screen
The Site ID screen, Figure 4.10, is available in stop-and-go and kinematic modes when
Known Point has been selected in the Initialize field. To access the site ID screen, select
Known Point in the Initialize field, then highlight the Site ID field and press Enter.
The
Site ID screen lets you select a known site ID with its associated site description during a
known point initialization. The site IDs listed are site IDs entered and occupied with the
control tag set to
Ye s. Table 4.7 describes the Site ID screen parameters.
Figure 4.10 Site ID Screen
Table 4.7 Site ID Screen Parameters
Parameter Description
CT23… etc. A list of the site IDs including associated site descriptors set as control during previous point
occupations. These are known initialization points. The table allows up to 50 known points.
With 50 points, the Control field in the Point Attribute screen is no longer editable.
Save Saves settings.
Delete Deletes the highlighted site ID in the Site ID table. The Site ID list is saved and can only be
cleared by using the Delete button or by selecting Clear All in the Navigation Setup menu.
