Filter
Top Products
06 Maintenance and specifications
195
Wheels and tyres
06
3. Place chocks in front of and behind the
wheels which will remain on the ground.
Use heavy wooden blocks or large
stones.
4. (For cars with steel rims.) Prise off the
wheel cover with the end of the wheel
wrench, or pull it off by hand.
5. Loosen the wheel nuts ½–1 turn anti-
clockwise with the wheel wrench.
6. There are two jacking points on each
side of the car. Crank the foot of the
jack down so it is pressed squarely on
the ground. Check that the jack sits in
the anchorage as illustrated and that the
foot is positioned vertically under the
anchorage.
7. Lift the car so that the wheel is free.
Remove the wheel bolts and lift off the
wheel.
Installation
1. Clean the contact surfaces on the wheel
and hub.
2. Put on the wheel. Screw in the wheel
bolts.
3. Lower the car so that the wheels cannot
rotate.
4. Tighten the wheel bolts crosswise. It is
important that the wheel bolts are tight-
ened properly. Tighten to 140 Nm.
Check the torque with a torque wrench.
5. Fit on the wheel cover (for cars with
steel rims).
7700603s
NOTE
The hubcap outlet for the valve must be lo-
cated over the valve on the rim when fitted.
7700605s
WARNING
Never crawl under the car when it is raised
on the jack.
Passengers must leave the car when it is
raised on the jack.
Park the car so that passengers have the
car - or preferably a crash barrier - between
them and the road.