Filter
Top Products
06 Maintenance and specifications
180
Lamps
06
Side marker lamps
1. Detach the headlamp.
2. Remove the small round cover.
3. Pull the cable in order to withdraw the
bulb holder.
4. Remove the blown bulb and fit a new
one. It can only be installed in one way.
5. Fit the bulb holder in the socket and
press until a clicking sound is heard.
6. Refit the cover. It must be fitted and
pressed in until a clicking sound is
heard.
Reinstall the parts in reverse order.
Fog lamps
1. Remove the cover by pressing in the clips
and pulling straight out.
2. Unscrew the lamp housing screw and
pull it out.
3. Turn the bulb anticlockwise and remove
it.
4. Fit a new bulb by turning clockwise.
5. Refit the bulb. (The profile of the bulb
holder corresponds to the profile of the
foot of the bulb.)
6. Refit the bulb holder. The TOP mark on
the bulb holder must always be upward.
Lamp housing, rear
The bulbs in the rear light cluster are re-
placed from inside the cargo area (not the
LED lamps).
1. Remove the covers in the left/right-hand
panel to access the bulbs. The bulbs are
located in separate bulb holders.
2. Press the catches together and pull out
the bulb holder.
3. Replace the bulb.
4. Plug in the connector.
5. Press the bulb holder into place and
refit the cover.
NOTE
Before starting to replace a bulb, see
page 177.
3501880s
3501874s
3501878s