Filter
Top Products
INSTALLATION DIRECTIVEMAY 2006
25
V08 ENT M75
-
M11
-
M12
Sensor to detect water in fuel
1. Prefilter - 2. Conductor to be connected
with the negative battery terminal -
3. Sensor to detect water in fuel.
CAUTION
In order to enable the proper working of the sensor to
detect water in fuel, the prefilter support needs to be
electrically connected to the negative battery terminal.
In the engine models which use parts with insulated poles
it is necessary to electrically insulate the prefilter support
from the boat mass and then connect the support with the
negative battery terminal.
Figure 22
Throttle lever position sensor
After testing the working condition of the linkage, adjust the
run of the servo components (see Chapter 15).
o With the throttle at idle setting, the potentiometer rod
has to be in the resting position;
o With the throttle at the stop, the potentiometer rod has
to be in the position of maximum run out.
Neutral gear sensor
CAUTION
When neutral gear sensor is installed remember to con-
nect it to GN connector.
In installation with no sensor, do not remove the cap of
the GN
connector to avoid compromising start engine
function
.
Figure 21
05_018_V
2
1
3
05_019_V