Filter
Top Products
8
TM
Permanent Dashboard or Console Mounting
To mount the device on a rough surface, such as your
dasboard or console, use the surface mount disk that
came with your device. This disk permanently mounts in
your car and provides a stable base for the suction cup
mount.
Determine the best location for the surface mount disc.
Attach the device to the support arm. Place the suction
cup at against the surface, and adjust the position so
you can easily see the display screen but your driving
view is not obstructed.
1.
Clean the surface where you plan to mount the disc. Be
sure to remove all protecterants, wax, and grease.
Carefully peel the protective sheet
from the bottom of the surface
mount disc to expose the adhesive.
Position the disc above the surface
in the desired location, Press the
disc rmly against the surface,
making sure that all parts of the
disc have good contact with the surface. Gently tug on the
disc to test the adhesive before mounting the support arm.
Press the suction cup rmly
into the surface mount disc and
push the suction lock down
towards the suction cup.
To release the suction cup,
pull the lock back towards the
support arm and lift the plastic
tab. Important: be ready to
support the device when it
releases from the windshield.
Connect the DC power cord to
the 11-15VDC jack. Then, insert the cigarrette-lighter plug
into a standard 12-volt outlet. The device automatically
turns on when you connect the power.
2.
3.
4.
5.
6.
7.
NOTE:
The surface mount disc is designed to
permanently stick to most surfaces. Attempting
to remove the disc may cause damge to the
surface. Be certain you have the disc in the
desired location before exposing the adhesive.