Toshiba TECRA A50-A/W50-A GPS Receiver User Manual


 
EU Declaration of Conformity
This product is carrying the CE-Mark in
accordance with the related European Directives.
Responsible for CE-Marking is TOSHIBA EUROPE
GMBH, Hammfelddamm 8, 41460 Neuss,
Germany. The complete and official EU
Declaration of Conformity can be found on
TOSHIBA’s web site http://epps.toshiba-teg.com
on the Internet.
CE compliance
This product is labelled with the CE Mark in accordance with the related
European Directives, notably RoHS Directive 2011/65/EU and
Electromagnetic Compatibility Directive 2004/108/EC for the notebook and
the electronic accessories including the supplied power adapter, the Radio
Equipment and Telecommunications Terminal Equipment Directive 1999/5/
EC in case of implemented telecommunication accessories and the Low
Voltage Directive 2006/95/EC for the supplied power adapter. Furthermore
the product complies with the Ecodesign Directive 2009/125/EC (ErP) and
its related implementing measures.
This product and the original options are designed to observe the related
EMC (Electromagnetic Compatibility) and safety standards. However,
TOSHIBA cannot guarantee that this product still observes these EMC
standards if options or cables not produced by TOSHIBA are connected or
implemented. In this case the persons who have connected/implemented
those options/cables have to provide assurance that the system (PC plus
options/cables) still fulfils the required standards. To avoid general EMC
problems, the following guidance should be noted:
Only CE marked options should be connected/implemented
Only best shielded cables should be connected
Working environment
This product was designed to fulfil the EMC (Electromagnetic Compatibility)
requirements to be observed for so-called “Residential, commercial and
light industry environments”. TOSHIBA do not approve the use of this
product in working environments other than the above mentioned
“Residential, commercial and light industry environments”.
For example, the following environments are not approved:
Industrial Environments (e.g. environments where a mains voltage of
380 V three-phase is used)
Medical Environments
Automotive Environments
Aircraft Environments
User's Manual
1-4