Filter
Top Products
When you use external display ports on the Port Replicator, some
software may show different type of ports which you connected.
When connecting an AC Adaptor to the Port Replicator, use only the
AC Adaptor included with Port Replicator. Do not use the computer’s
AC Adaptor.
Refer to the Port Replicator’s User's Manual for more details.
To dock your computer in the Port Replicator, follow the steps below:
1. Align the top right corner of your computer to the C’ mark on the Port
Replicator.
2. Press down on the back of the computer until it clicks into place. The
computer connector on the port replicator engages the computer’s
docking port.
When the computer is connected, the Docked light glows green.
Figure 4-26 Aligning your computer with the Port Replicator
1
1. Docking port (computer)
Make sure the AC adaptor is always connected to the TOSHIBA Hi-
Speed Port Replicator III 180W/120W while in use. Otherwise the Port
Replicator will stop working, possibly resulting in data loss.
TOSHIBA Docking Station Utility
Models with a docking port support system sleep undocking operation.
You can enable/disable the system sleep undocking operation. If enabled,
the computer goes into Sleep Mode when you undock the computer.
You can undock the computer in one of the following ways:
User's Manual
4-54