Filter
Top Products
Series 220/221 Instruction Manual Chapter 3 Operation
Display Menu
Password
ENTER
Use
keys to access menus
Display
Menu
Cycle Time(sec)
0
ENTER
Run Mode
Number of Digits
2
Display VFlow?
YES or NO
Display MFlow?
YES or NO
If Cycle Time is set to zero, manual advance is required
Used to set the number of digits displayed after
decimal point
For each parameter:
Select Yes to view parameter in Run Mode
Select No to hide parameter in Run Mode
Display TC(sec)
1
TC = Display Time Constant, used to smooth display
Display Total?
YES or NO
Use the Display Menu to set the cycle time for automatic screen sequencing used in the Run Mode,
change the precision of displayed values, smooth the values or enable or disable each item displayed
in the Run Mode screens.
Example for Changing a Run Mode Display Item
The following shows how to remove the mass flow screen from the Run Mode screens. Note: all outputs are
disabled while using the Setup Menus.
1. Use ÕÖ keys to move to the Display Menu.
2. Press Ø key until Display MFlow? appears.
3. Press
ENTER to select.
4. Press Ø key until N appears. Press
ENTER to select.
5. Press EXIT and then
ENTER to save changes and return to the Run Mode.
IM-22 3-5