Filter
Top Products
Chapter 2 Installation Series 220/221 Instruction Manual
Enclosure Adjustment (Series 220 Only)
Figure 2-13. Enclosure Viewing Adjustment
To avoid damage to the sensor wires, do not rotate the enclosure beyond 180-
degrees from the original position. To adjust the enclosure:
1. Remove power to the flow meter.
2. Loosen the three set screws shown above. Rotate the display to the de-
sired position (maximum 180-degrees).
3. Tighten the three set screws. Restore power to the meter.
2-18 IM-22