Using the Call Command
1. Press and hold
b g for
two seconds. The system
responds with “Ready”
followed by a tone.
2. Say “Call”. The system responds
with “Call using <phone name>.
Please say the name tag”
followed by a tone.
3. Say the name tag of the person
to call.
• If the system clearly
recognizes the name tag it
responds with “OK, calling,
<name tag>” and dials
the number.
• If the system is unsure it
recognizes the right name
tag, it confirms the name tag
followed by a tone. If the name
tag is correct, say “Yes”.
The system responds with
“OK, calling, <name tag>” and
dials the number. If the name
tag is not correct, say “No”.
The system will ask for the
name tag to be re-entered.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re-dial Command
1. Press and hold
b g for
two seconds. The system
responds with “Ready”
followed by a tone.
2. After the tone, say “Re-dial”.
The system responds with
“Re-dial using <phone name>”
and dials the last number
called from the connected
Bluetooth phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a
ring tone is heard in the vehicle.
• Press b g and begin speaking
to answer the call.
• Press c x to ignore a call.
Call Waiting
Call waiting must be supported on
the Bluetooth phone and enabled by
the wireless service carrier to work.
• Press b g to answer an
incoming call when another call is
active. The original call is placed
on hold.
• Press b g again to return to the
original call.
• To ignore the incoming call,
continue with the original call
with no action.
• Press c x to disconnect the
current call and switch to the call
on hold.
3-110 Instrument Panel