Filter
Top Products
Turn and Lane-Change
Signals
The turn signal has two upward and
downward positions to signal a turn
or a lane change.
To signal a turn, move the lever all
the way up or down, past the detent.
The lever returns to its starting
position when released.
An arrow on the instrument panel
cluster flashes in the direction of
the turn or lane change.
To signal a lane change, raise or
lower the lever until the arrow starts
to flash, and then release the lever.
Do not move the lever past the
detent. The turn signal will
automatically flash three times
and turn off.
To cancel it before turning, move
the lever slightly in either direction.
Do not past the detent.
Headlamp High/
Low-Beam Changer
23
(Headlamp High/Low
Beam Changer): To change the
headlamps from low to high beam,
push the multifunction lever towards
the instrument panel. To return to
low-beam headlamps, push the lever
towards the instrument panel again
or pull the lever toward you. Then
release it.
This indicator light on the instrument
panel cluster is on while the high
beam headlamps are on.
Flash-to-Pass
Pull the turn signal/multifunction
lever towards you to flash the high
beams from low beam.
4-8 Instruments and Controls