Filter
Top Products
4
• Route wiring properly according to the instructions. An incorrect connection might cause a fire or
accident.
• Be careful and prevent the wiring harness from being pinched between the vehicle body, screws,
or moving parts such as the seat rails. It could cause an accident, electrocution, or fire due to an
open or short circuit.
• The Rear View Back up Camera System is for in-car use only and is not to be used outside of the
vehicle. If it is used outside of the vehicle it could result in electrocution or other injury.
• Install the camera on the vehicle during sunny, daytime hours. If installed in rainy or foggy
weather, high humidity will weaken the adhesion strength of the double-sided adhesive tape, and
the camera may fall off, resulting in an accident or injury.
• Avoid moisture such as water, rain, fog, snow or applying excessive force to the camera for 24
hours after installation. The adhesion strength of the double-sided adhesive tape will weaken and
the camera may fall off, resulting in an accident or injury.
• Be careful when handling the double-sided adhesive tape. Touching the sticky surface of the tape
or re-attaching the bracket weakens the adhesion strength. The bracket may fall off, resulting in
an accident or injury.
• This Rear View Back up Camera System has been designed to assist the driver in confirming the
rear view when backing up the vehicle into a garage or when parallel parking. For safety reasons,
it is important for the driver to take extra precautions when backing up.
• Power Supply························································DC 12 V (DC 11 V to DC 16 V) Negative ground
• Max. Consumption Ampere ·····················································································Approx. 300mA
• Viewing System ····································································· Mirror Image*
(for vehicle reversing)
• Imaging Device·········································································································Color CCD, ¼”
• Number of Pixels ···············································Total: 270 K pixels. Effective: Approx. 250 K pixels
• Viewing Angle······························· Horizontal: Approx. 135 degrees, Vertical: Approx. 105 degrees
(Standard rear view is displayed)
• Min. Required luminance····························································································Approx. 1.6 lx
• Output Signal··································································1Vp-p (75 ohm, NTSC), RCA-type socket
• Operation Temperature····························································································· -4°F to +140°F
• Storage Temperature ······························································································-22°F to +176°F
• Camera Dimensions···················································· W1.1” x H0.9” x D1.0” (without protrusions)
• ECU Dimensions ························································· W3.4” x H1.1” x D2.6” (without protrusions)
• Camera Weight·············································································Approx. 0.35lbs (including cable)
• ECU Weight ·············································································································Approx. 0.37lbs
*Mirror image: The camera produces an image on the screen with the left and right appearing
reversed the same as when looking into the rear view mirror or the door mirrors.
• Specifications may change at any time without prior notification.
SPECIFICATION