Filter
Top Products
18
Alignment Mode
Turn the ignition switch to the ACC ON position while
depressing the control switch.
• Press and hold the control switch until the screen
appears.
View-from-top alignment screen appears.
(Seven rectangles at top left indicate seven items to
align.)
If adjustment mode cannot be selected
1. Turn the ignition switch to the ACC ON position while pressing the switch. Press and hold the
switch for two seconds or more.
2. Turn the monitor on so that rear view images captured by the camera can be seen.
• If any view is not displayed on the screen, turn the ignition switch to the ON position (without
starting the engine) and set the shift lever to R (reverse).
• Depending on the navigation system or external monitor connected to this accessory, the
operation can be interlocked with the reverse gear.
• If the vehicle is left with the ignition switch in the ON position for long periods of time, the
battery power could be depleted.
Alignment
Note: Follow the alignment procedures in the indicated order from 1 to 7. Each of the below alignment
steps is indicated by a flashing rectangle corresponding to each alignment item, moving from left to
right with each rectangle having a different color.
1. View-from-top angle alignment (White)
2. Center-line alignment (Red)
3. View-from-top height alignment (Violet)
4. Left/right guide lines alignment (Yellow)
5. Right guide line alignment (Green)
6. 3 ft. guide line alignment (Light Blue)
7. 1.5 ft. guide line alignment (Blue)
• If no picture appears on the screen, turn the monitor power on and change the
input selector so that the screen of the rear view back up camera system appears.
(Check the connection between video output terminal of ECU box and the camera
or video input terminal of the monitor.) (Refer to the manual for the monitor)
CAUTION
• If no alignment procedure is commenced for three minutes or longer, the system
turns the image off and the set parameters will NOT be stored.
• Do not leave the ignition switch in the ACC ON position for a long period of time as it
could deplete the battery power.
• Black triangles at the bottom on both sides appear when the display mode is set to
View-from-top. This does not indicate a malfunction. In addition, depending on the
center-line alignment position, the size of each of the triangles could differ.
Notes
Seven rectangles at top left indicate
seven items to align
Need help? Call
1-800-421-5013