Filter
Top Products
15
CABLE ROUTING
The following is an example when installing the camera on the rear spoiler.
1. Route the camera cable along the top of the liftgate
and secure the cable with the cable clamps included
with the Rear View Back up Camera System.
Straighten the cable along the top of the spoiler (or
liftgate) and insert it through the opening at the side
of the liftgate.
• Give the cable some slack to enable smooth
opening and closing of the liftgate.
2. Route the camera cable down to the lower part of
the liftgate and secure it with the cable clamps.
Route the cable to the outside of the liftgate hinge
and harness cover.
• Route the cable carefully so that the cable is not
pinched when the door opens and closes.
• Route the cable carefully to prevent water
penetration.
• Route the cable so that it does not block or obstruct vehicle operation.
• Route the rear view camera cable as far away from the vehicle antenna as
possible to prevent noise interference with AM radio band reception. Also, route
the cable as far as possible from a TV antenna, if equipped.
• Clean the areas where the cable clamps and waterproof pad are to be attached.
Wipe out oil, wax, moisture, dirt and dust with a cleaner and a clean cloth.
CAUTION
Control switch
Camera
ECU box
Cable clamp
Hinge
Harness cover
Cable clamp
Cable tie
Cable clamp
Camera
Cable clamp
Cable
clamp
Need help? Call
1-800-421-5013