86 ST7001+ Autopilot Control Unit - Owner’s Handbook
7 Adjusting Autopilot Settings
• Maxiview instruments: use the resp key to toggle between
group letter and sequence number, and the
track key to set the
identifying character.
When you have identified the instrument, it should display its
group letter and sequence number, e.g.
A2.
Note: You can select all instruments in Group Setup mode.
6. Press either the up arrow or down arrow key to select another
instrument and repeat the procedure in step 5.
7. Repeat steps 5 and 6 until all you have identified all instruments in
the group.
Note: If you have more than eight ST60 or ST80 instruments, you
must create a second group with a separate identification code (for
example
B1, B2 etc.), operated by another remote keypad.
8. Use the arrow keys to select an instrument in the group to which
you want to allocate the ST7001+ as a keypad.
9. Press the up and down arrow keys together for 1 second. The
ST7001+ screen text will alternate between:
•
INST REM and KPD SETUP for standard instruments
•
MAXI REM and KPD SETUP for Maxiview instruments
Each instruments in the selected group will display
PRESS KEY.
10. To allocate the ST7001+ to the selected group of instruments:
• press the
track or set crs key for standard instruments
• press the
resp or track key for Maxiview instruments
11. If you are creating more than one group, repeat steps 3 to 10 for
each group.
12. When you have set up all instrument groups, return to normal
operation as follows:
• standard instruments:
• press the
track and set crs keys for 1 second to return to
Group Setup mode
• then press the
track and set crs keys again for 2 seconds
to return to normal operation
• Maxiview instruments:
• press the
resp and track keys for 1 second, to return to
Group Setup mode
• press the
resp and track keys again for 2 seconds to
return to normal operation.
