Olympus DM-420 Automobile Battery Charger User Manual


 
15
1
Power supply
Notes
• Manganese batteries may not be used in
this recorder.
• When changing batteries, AAA alkaline
batteries or Olympus Ni-MH rechargeable
batteries are recommended.
• Be sure to stop the recorder before
replacing the batteries. Unloading the
batteries while the recorder is in use may
corrupt the le. If you are recording into
a le and the batteries run out, you will
lose your currently recorded le because
the le header will not be able to close.
It is crucial to change the batteries once
you see only one Hash mark in the battery
indicator.
• If it takes longer than 15 minute to replace
the dead batteries or if you take the
batteries in and out repeatedly at short
intervals, you may have to reset the time
when you have loaded fresh batteries
( P.20).
• Remove the batteries if you are not going
to use the recorder for an extended period
of time.
• When playing a voice/music le, the
recorder may be reset due to the
reduction of the voltage output of the
batteries depending on the volume level
even if [8] is displayed in the battery
indicator. In this case, lower the volume of
the recorder.
• When replacing rechargeable batteries, be
sure to use Ni-MH rechargeable batteries.
The use of other manufacturers' products
can damage the recorder and should be
avoided.
Power supply
Charging by connecting to a
computer via USB
You can charge the batteries by connecting
to a PC's USB port. When charging, be sure
to correctly place the rechargeable batteries
(supplied) into the recorder ( P.14).
Do not charge primary batteries such as
alkali or lithium batteries. It may cause
battery leakage heating and recorder
malfunction.
1 Boot the PC.
2 Connect the USB connection
cable to the USB port of the PC.
3 In the Stop or Hold status,
connect the USB cable to the
connecting terminal on the
bottom of this recorder while
pressing the
STOP
4 button.
[Batt.Charge mode] appears in the
display while pressing the STOP 4
button.
Press and hold the STOP
4 button
until [Charging] appears in the
display.