Filter
Top Products
64 – 65
02 Prior to commissioning
– Do not follow the instructions of the
navigation system unless the circum-
stances and the traffic regulations allow
you to do so ! Should it be necessary to
deviate from the calculated route, the
navigation system will automatically
calculate a new route.
!
Note: should the spoken instructions not be
clear, the map and arrow display serves as an
additional aid to orientation.
2.5.2 Safety guidelines when installing in your car
!
Caution !
– Make sure you do not attach the holder
within the deployment zone of the airbag.
– When installing the holder, you should
ensure that it will not present a safety risk
in the event of an accident.
2.5.3 Safety instructions for the navigation device
!
Caution !
– The navigation device is to be kept dry as
it is not water resistant.
– Do not lay the cable directly next to safety-
relevant devices and supply lines.
– After installation, all safety-relevant
systems in the car should be checked.
– When leaving the car, pull the charging
cable connector out of the cigarette lighter
socket, otherwise the GPS receiver will
continually consume power and the car
battery could discharge.
– Please use only accessories designed for
this model.
– Please do not expose the device or the
battery to temperatures above 60°C.
Note:
– only use a moist cloth for cleaning and
do not use aggressive solvents. The case
of the navigation device may otherwise
be damaged.
– the connector should not be pulled out by
the cable as this may damage it !
– do not kink the cable and ensure that it
does not become damaged by sharp
objects.
3.1 Volume
The volume of the spoken driving instructions from
the P´ 9611 can be adjusted during navigation using
the volume control or software as follows.
You have started navigation. The map is in
NAVIGATION or DESTINATION SEARCH mode.
1. Touch the
VOLUME button.
The volume bar opens. It contains three
buttons for adjusting the volume.
LOUDER
QUIETER
VOLUME ON / OFF
2. Touch the
VOLUME button again.
The volume bar closes.
3.2 Information
Symbols located at the top of the screen are used
to display information.
GPS
The GPS symbol can show the following GPS-
reception status:
NO GPS: The built-in GPS receiver is not
operational. If this problem persists, consult
customer service.
NO SIGNAL (red): Data are being received from
less than three satellites. The position cannot be
calculated.
GPS READY (grey): Data are being received
from at least three satellites. The position can be
calculated.
i
Refer to chapter “GPS status” on page 83 for
detailed information regarding the GPS status.
Energy
The ENERGY symbol can display the following
conditions of the built-in battery:
The device is being supplied by an external
power source. The battery is being charged.
The device is being supplied by its internal
battery. The battery charge is sufficient.
The device is being supplied by its internal
battery. The battery charge is low.
Direction
The DIRECTION symbol shows you in which
direction you are currently moving. It can show the
following points of the compass: N, NE, E, SE, S,
SW, W, NW.
TMC
[
Traffic information
]
The TMC symbol can display the following TMC
states:
NO SYMBOL: The built-in TMC receiver is not
operational. If this problem persists, consult
customer service.
TUNING (red): The TMC receiver is operational,
but cannot find a transmitter that is sending TMC
signals.
TMC ON STANDBY (grey): Traffic messages
can be received.
i
For details of the TMC functions, please refer to
chapter “TMC
[
Traffic Information
]
”, page 83.
03 Operating the Navigation Software
!