Filter
Top Products
4G1 ENGINE (E-W) -
Crankshaft and Cylinder Block
11A-12-7
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
"
C
A
BEARING CAP INSTALLATION
(1) On the bottom surface of each bearing cap is the cap’s
number and an arrow. Starting at th e timing belt side,
fit the bearing caps in numerical order. Ensure that the
arrows point toward the timing belt side.
(2) After fitting the bearing caps, measure the end play in
the crankshaft. If the measurement exceeds the specified
limit, replace the crankshaft bearings.
Standard value: 0.05 - 0.18 mm
Limit: 0.25 mm
"
D
A
REAR OIL SEAL INSTALLATION
(1) Press-fit the rear oil seal using the special tool shown
in the illustration.
PWEE9520-A
E
Dec. 1998Mitsubishi Motors Corporation Added
Arrow indicating front
of engine
Cap No.
3EN0174
Oil seal
Oil seal case
MD998011