Filter
Top Products
4G1 ENGINE (E-W) -
Oil Pump and Oil Pan
11A-10-2
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
REMOVAL SERVICE POINTS
A
A
"
OIL PAN REMOVAL
(1) Remove the oil pan mounting bolts.
(2) Knock the special tool between the oil pan a nd cylinder
block as shown in t he illustration.
(3) Tapping the side of the special tool, slide the tool along
the oil pan/cylinder block seal and thus remove the oil
pan.
INSPECTION
1. OIL PUMP
(1) Fit the rotor into the front case.
(2) Check the tip clearance using a thickness gauge.
Standard value: 0.06 - 0.18 mm
(3) Check the side clearance using a straight edge and
thickness gauge.
Standard value: 0.04 - 0.10 mm
(4) Check the body clearance using a thickness gauge.
Standard value: 0.04 - 0.10 mm
Limit: 0.35 mm
MD998727 MD998727