Filter
Top Products
4G1 ENGINE (E-W) -
Cylinder Head and Valves
11A-9-9
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
"
B
A
VALVE SPRING INSTALLATION
(1) Install the valve spring such that its painted en d is on
the rocker arm side.
"
C
A
RETAINER LOCK INSTALLATION
"
D
A
CYLINDER HEAD BOLT INSTALLATION
(1) Beforereusing the cylinderhead bolt, check that itsnominal
length does not exceed the specified limit. Replace the
bolt if this measurement exceeds the limit.
Limit: 103.2 mm
(2) Fit the washer as shown.
(3) Apply engine oil to the bolt’s thread and washer.
PWEE9520-A
E
Dec. 1998Mitsubishi Motors Corporation Revised
Painted
end
Spring
retainer
Stem seal
Spring seat
MD998772
SOHC
DOHC
MD998772
MD998735