Filter
Top Products
4D68 ENGINE (E- W) -
Front Case, Counterba la nc e Shaft s and Oil Pan
11A-10-3
A
E
"
RIGHT COUNTERBALANCE SHAFT REAR
BEARING / LEFT COUNTERBALANCE SHAFT
REAR BEARING REMOVAL
(1) Using th e special tool, remove two rear bearings from
the cylinder block.
(2) To remove the left rear bearing, install the special tool,
Silent Shaft Bearing Installer Stopper, to the front of the
cylinder block, then remove the bearing using the special
tool, Silent Shaft Bearing Puller.
INSTALLATION SERVICE POINTS
"
A
A
LEFT COUNTERBALANCE SHAFT REAR
BEARING INSTALLATION
(1) Install the special tool in the cylinder block.
(2) Apply engine oil to the rear bearing outer circumference
and bearing hole in the cylinder block.
NOTE
The left side bearing is provided with no oil hole.
(3) Using the special tool, install the bearing.
"
B
A
RIGHT COUNTERBALANCE SHAFT REAR
BEARING INSTALLATION
(1) Install the guide pin of the special tool to the threaded
hole of the cylinder block as illustrated.
(2) Install the bearing to the special tool, aligning the ratchet
ball of the special tool with the oil hole of the rear bearing.
(3) Apply engine oil to the outer circumference of the bearing
and to the bearing hole of the cylinder block.
PWEE9609
E
Dec. 1996Mitsubishi Motors Corporation
6EN0207
MD998732
MB991603
6EN0208
MD998705
MB991603
6EN0578
MD998705
MB991603
Rear bearing
6EN0774
Guide pin
6EN324
Oil
hole
Ratchet ball
Rear bearing (right)