Filter
Top Products
4D68 ENGINE (E- W) -
Timing Belt
11A-4-5
(3) Make sure that the pulley center and the bolt center are
located as shown in the illustration.
(4) More th e tensioner “B” in the direction of arrow while lifting
with a finger to give a sufficient tension to the tension
side of the timing belt. In this condition, tighten the bolt
to secure tensioner “B”. When the bolt is tightened, use
care to prevent the shaft from turning together. If the shaft
is turned together, the belt will be overtensioned.
(5) Check to ensure that the timing marks on the sprockets
and the front case are in alignment.
(6) Press with index finger the center of span on the tension
side of timing belt “B”. The bolt must deflect 5 to 7 mm.
"
D
A
OIL PUMP SPROCKET INSTALLATION
(1) Keep the counterbalance shaft in position in the same
way as when it was loosened.
(2) Install the oil pump sprocket.
(3) Apply a minimum quantity of engine oil to the bearing
surface of the nut.
(4) Tighten the nuts to the specified torque.
"
E
A
CRANKSHAFT BOLT TIGHTENING
PWEE9609
E
Dec. 1996Mitsubishi Motors Corporation
DEN0749
Timing belt “B”
Tensioner pulley
center
Tensioner “B”
DEN0750
DEN0751
5-7mm
6EN0564
Phillips screwdriver
DEN0743
MD998781