Filter
Top Products
Overhead control panel
:
To raise
;
To open
=
To close
X
Switch on the ignition.
X
Push or pull the 2 switch in the
corresponding direction.
i
If you press the 2 switch beyond the
point of resistance, an automatic opening/
closing process is started in the
corresponding direction. You can stop
automatic operation by pressing again.
Automatic opening/raising is only available
if the tilt/sliding sunroof is in the closed
position.
You can open/close the cover for the
sunblind manually when the tilt/sliding
sunroof is raised/closed.
Resetting
Reset the tilt/sliding sunroof if it does not
open smoothly, or if the battery has been
disconnected or has become discharged.
!
Contact a qualified specialist workshop if
the tilt/sliding sunroof cannot be closed
fully or reset.
X
Remove the SmartKey from the ignition
lock or turn to position 0 (KEYLESS-GO).
X
Remove the fuse for the tilt/sliding sunroof
from the main fuse box. To find out where
the fuse is located, refer to the fuse
allocation chart in the vehicle tool kit
(Y page 310).
X
Reinsert the fuse.
X
Switch on the ignition.
X
Raise the tilt/sliding sunroof fully at the
rear (Y page 89).
X
Keep the 2 switch pressed for another
second.
X
Make sure that the tilt/sliding sunroof can
be opened or closed fully again using the
opening/closing process (Y page 89).
X
If the tilt/sliding sunroof can be raised fully
at the rear it is set correctly. If this is not
the case, you must repeat the previously
described steps.
Problems with the sliding sunroof
Problem: the sunroof cannot be closed
and you cannot see the cause.
G
Warning!
You could be severely or even fatally injured
when closing the sliding sunroof with
increased closing force or if the anti-
entrapment feature is deactivated. Make sure
that nobody can become trapped when
closing the sliding sunroof.
If the sliding sunroof is obstructed during
closing:
X
Immediately after the sliding sunroof
blocks, pull the 2 switch in the
overhead control panel down to the point
of resistance and hold it until the sliding
sunroof is closed.
The sliding sunroof is closed with increased
force.
If the sliding sunroof is obstructed during
closing again:
X
Immediately after the sliding sunroof
blocks, pull the 2 switch in the
overhead control panel down to the point
of resistance and hold it until the sliding
sunroof is closed.
The sliding sunroof is closed without the
anti-entrapment feature.
90
Sliding sunroof
Opening and closing
BA 164.8 USA, CA Edition B 2011; 1; 2, en-US
d2sboike Version: 3.0.3.5
2010-04-21T15:08:44+02:00 - Seite 90