Filter
Top Products
i
When you insert Start/Stop button :
into ignition lock ;, the system requires a
detection time of two seconds before you
can use Start/Stop button :.
X
Shift the transmission to position P.
X
Do not press the brake pedal.
Start/Stop button
=
USA only
?
Canada only
X
Position 0: if Start/Stop button : has not
yet been pressed, this corresponds to the
SmartKey being removed from the ignition.
X
Position 1: press Start/Stop button :.
You can now activate the windshield
wipers, for example.
i
If you then open the driver's door when in
this position, the power supply is
deactivated.
X
Position 2 (ignition): press Start/Stop
button : twice.
i
If you press Start/Stop button : once
when in this position and the driver's door
is open, the power supply is deactivated
again.
As soon as the ignition is switched on, all the
indicator lights in the instrument cluster light
up. The indicator lamps of the low-beam
headlamps, high-beam headlamps or the turn
signal lamps only light up if the low-beam
headlamps, high-beam headlamps or turn
signal lamps are switched on. If an indicator
lamp does not light up when the ignition is
switched on, check it and replace it if
necessary. If an indicator lamp does not go
out after the engine is started or if it lights up
while the vehicle is in motion, see
(Y page 254).
Starting the engine
Important safety instructions
G
Warning
Inhalation of exhaust gas is hazardous to your
health. All exhaust gas contains carbon
monoxide (CO), and inhaling it can cause
unconsciousness and possible death.
Do not run the engine in confined areas (such
as a garage) which are not properly ventilated.
If you think that exhaust gas fumes are
entering the vehicle while driving, have the
cause determined and corrected
immediately. If you must drive under these
conditions, drive only with at least one
window fully open at all times.
!
Do not depress the accelerator pedal
when starting the engine.
Automatic transmission
X
Shift the transmission to position P.
i
The transmission position display in the
multifunction display shows P.
Starting procedure with the SmartKey
X
To start a gasoline engine: turn the
SmartKey to position 3 in the ignition lock
(Y page 147) and release it as soon as the
engine is running.
X
To start a diesel engine: turn the
SmartKey to position 2 in the ignition lock
(Y page 147).
The % preglow indicator lamp in the
instrument cluster lights up.
X
When the % preglow indicator lamp
goes out, turn the SmartKey to position 3
148
Driving
Driving and parking
BA 164.8 USA, CA Edition B 2011; 1; 2, en-US
d2sboike Version: 3.0.3.5
2010-04-21T15:08:44+02:00 - Seite 148