Filter
Top Products
Combination switch
Turn signals
:
High-beam headlamps
;
Right turn signal
=
High beam flasher
?
Left turn signal
X
To indicate briefly: press the combination
switch briefly to the pressure point in the
direction of arrow ; or ?.
The corresponding turn signal flashes three
times.
X
To indicate: press the combination switch
beyond the pressure point in the direction
of arrow ; or ?.
High-beam headlamps
X
To switch on the high-beam headlamps:
turn the key in the ignition lock to position
2 or start the engine.
X
Turn the light switch to L.
X
Press the combination switch beyond the
pressure point in the direction of
arrow :.
The K indicator lamp in the instrument
cluster lights up.
X
To switch off the high-beam
headlamps: move the combination switch
back to its normal position.
The K indicator lamp in the instrument
cluster goes out.
High beam flasher
X
To switch on: turn the key in the ignition
lock to position 1 or 2 or start the engine.
X
Pull the combination switch briefly in the
direction of arrow =.
Hazard warning lamps
The hazard warning lamps automatically
switch on:
R
if an air bag is deployed
R
the vehicle decelerates rapidly from a
speed of more than 45 mph (70 km/h) and
comes to a standstill.
X
To switch on the hazard warning lamps:
press button :.
All turn signals flash. If you now switch on
a turn signal using the combination switch,
only the turn signal lamp on the
corresponding side of the vehicle will flash.
X
To switch off the hazard warning
lamps: press button :.
The hazard warning lamp switches off
automatically after full brake application if the
vehicle then reaches a speed above
6 mph (10 km/h) again.
i
The hazard warning lamps still operate if
the ignition is switched off.
Headlamp cleaning system
The headlamps are cleaned automatically if
the "Wipe with washer fluid" function is
Exterior lighting
117
Lights and windshield wipers
BA 164.8 USA, CA Edition B 2011; 1; 2, en-US
d2sboike Version: 3.0.3.5
2010-04-21T15:08:44+02:00 - Seite 117
Z