Filter
Top Products
X
Insert the bulb holder and turn it clockwise.
X
Close the side trim panel (Y page 123).
License plate lamp
X
Switch off the lights.
X
Open the tailgate.
X
Remove screws :.
X
Remove the license plate lamp.
X
Replace the bulb.
X
Insert the license plate lamp.
X
Replace and tighten screws :.
Setting the headlamps
:
V vertical axis
;
H (horizontal) height, measured from the
center
Setting the headlamps correctly is extremely
important. Setting the high-beam headlamps
also sets the low-beam headlamps. (The term
headlamps covers both high and low beam.)
To check and adapt the headlamp setting,
proceed as follows:
X
Park the vehicle on level ground at a
distance of 25 feet (7.6 m) from a wall or
similar.
X
Make sure that the vehicle load is in the
normal range.
X
Switch on the L low-beam headlamps.
If the light of the headlamps is not distributed
as shown in the illustration above, follow the
instructions below:
X
Open the hood (Y page 294).
The adjustment screws are located under the
cover.
X
Insert a suitable tool into the openings in
the cover. The directions of arrow =
and ? indicate the angle at which the tool
needs to be inserted in order to reach the
adjustment screws.
X
Turn both screws uniformly until the
vertical setting corresponds to :. Turn the
screws clockwise to adjust the headlamp
upwards and counterclockwise to adjust it
downwards.
Gradation:
R
Screw at arrow =: 0.67˚ angle of
inclination
R
Screw at arrow ?: 0.50˚ angle of
inclination
The left and right headlamp need to be
adjusted individually.
i
If it is not possible to adjust the
headlamps accurately, have the
124
Changing bulbs
Lights and windshield wipers
BA 164.8 USA, CA Edition B 2011; 1; 2, en-US
d2sboike Version: 3.0.3.5
2010-04-21T15:08:44+02:00 - Seite 124