Filter
Top Products
Panorama roof with power tilt/sliding panel
205
Opening
X
Opening manually: Press and hold the
roof panel switch to the resistance point in
direction of arrow 2.
X
Release the roof panel switch when the
desired position is reached.
X
Express operation: To open the tilt/
sliding panel completely, press the roof
panel switch past the resistance point in
direction of arrow 2 and release.
X
Stopping during Express operation:
Move the roof panel switch in any direction.
i
When the tilt/sliding panel is open,
resonance noises may result in addition to
the usual wind noises. They are caused by
minimal pressure changes in the passenger
compartment. To reduce or eliminate these
noises, change the position of the tilt/
sliding panel or open a window slightly.
Raising
X
Rasing manually: Press and hold the roof
panel switch to the resistance point in
direction of arrow 1.
X
Release the roof panel switch when the
desired position is reached.
Closing
X
Closing manually: Pull and hold the roof
panel switch to the resistance point in
direction of arrow 3.
X
Release the roof panel switch when the
desired position is reached.
Closing when the tilt/sliding panel is
blocked
G
Warning!
Make sure that nobody can become
trapped and be seriously or even fatally
injured when closing the tilt/sliding panel
without automatic reversal function.
If the movement of the tilt/sliding panel is
blocked during the closing procedure, the
tilt/sliding panel will stop and open slightly.
X
Immediately after the tilt/sliding panel has
stopped because it was blocked, pull the
roof panel switch in direction of arrow 3
(Y page 203) until the tilt/sliding panel is
fully closed.
If the tilt/sliding panel is blocked again and
opens slightly:
X
Immediately after the tilt/sliding panel was
blocked, pull the roof panel switch in
direction of arrow 3 until the tilt/sliding
panel is fully closed.
G
Warning!
Pulling and holding the roof panel switch to
close the tilt/sliding panel immediately
after it had been blocked two times will
cause the tilt/sliding panel to close without
any reversal function for as long as you hold
the roof panel switch.
Synchronizing
The tilt/sliding panel and roller sunblinds
must be synchronized
R
after the battery has been disconnected or
discharged
R
after a malfunction
R
if the tilt/sliding panel does not open
smoothly
!
Do not attempt to open or close the tilt/
sliding panel before the tilt/sliding panel is
properly synchronized. The tilt/sliding
panel could otherwise lock-up in the open
position.
If the tilt/sliding panel cannot be closed or
synchronized, contact an authorized
Controls in detail
Z