Filter
Top Products
125
Controls in detail
Control system
Lighting submenu
Access the
LIGHTING
submenu via the
SETTINGS
menu. Use the
LIGHTING
submenu to change the lamp and lighting
settings on your vehicle. The following
functions are available:
Setting daytime running lamp mode
(USA only)
̈ Move the selection marker with
the
æ or ç button to the
LIGHTING
submenu.
̈ Press button j or k repeatedly
until you see this message in the
display:
LAMP CIRCUIT HEADLAMP MODE
.
The selection marker is on the current
setting.
̈ Press æ or ç to select manual
or daytime running lamp (constant)
mode. This function is not available in
countries where daytime running
lamps are mandatory.
With daytime running lamp mode
selected and the exterior lamp switch
at position 0, the following lamps will
come on automatically when the
engine is turned on:
ț Parking lamps and low beam
headlamps
ț License plate lamps (in low ambient
light conditions)
Function Page
Set daytime running lamp mode
(USA only)
see
below
Set locator lighting 126
Exterior lamps delayed shut-off 126
Interior lighting delayed shut-off 127
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
LIGHTING
submenu to factory settings
(
୴ page 120) will not reset the daytime
running lamp mode.
In the display you will then see the
message:
LIGHTING – CANNOT BE
COMPLETELY RESET TO FACTORY
SETTINGS WHILE DRIVING
!.