Filter
Top Products
Black plate (76,1)
CAUTION
Radio equipment like this is governed
by laws.
Changes or modifications not
expressly approved by the party
responsible for compliance could void
the user's authority to operate the
equipment.
NOTE
l
The keyless entry system operation may
vary due to local conditions.
l
The keyless entry system is fully operational
(door/trunk lid lock/unlock) when the push
button start is switched off. The system does
not operate if the push button start is
switched to any position other than off.
l
If the key does not operate when pressing a
button or the operational range becomes
too small, the battery may be dead. To
install a new battery, refer to Replace
Electrical Battery(page 6-32).
l
Additional keys can be obtained at an
Authorized Mazda Dealer. Up to 6 keys can
be used with the keyless functions per
vehicle. Bring all keys to an Authorized
Mazda Dealer when additional keys are
required.
qTransmitter
NOTE
l
(With theft-deterrent system)
The hazard warning lights flash when the
theft-deterrent system is armed or turned
off.
Refer to Theft-Deterrent System on page
3-42.
l
(With the advanced keyless function)
A beep sound can be heard for confirmation
when the doors and trunk lid are locked/
unlocked using the key. If you prefer, the
beep sound can be turned off.
The volume of the beep sound can also be
changed.
Refer to Personalization Features on page
9-8.
Use the following procedure to change the
setting.
1. Switch the ignition off and close all of the
doors and the trunk lid.
2. Open the driver's door.
3. Within 30 seconds of opening the driver's
door, press and hold the LOCK button on
the key for 5 seconds or longer.
All of the doors and the trunk lid lock and
the beep sound activates at the currently set
volume. (If the beep sound is currently set
to not activate, it will not activate.) The
setting changes each time the LOCK button
on the key is pressed and the beep sound
activates at the set volume. (If the beep
sound has been set to not activate, it will
not activate.)
4. The setting change is completed by doing
any one of the following:
l
Switch the ignition to ACC or ON.
l
Close the driver's door.
l
Open the trunk lid.
l
The key is not operated for 10 seconds.
l
Press any button except the LOCK
button on the key.
l
A request switch is pressed.
3-4
Before Driving
Keys
Mazda6_8DL2-EA-13F_Edition1 Page76
Monday, June 10 2013 3:52 PM
Form No.8DL2-EA-13F