Filter
Top Products
Black plate (21,1)
4. Perform one of the following settings
within 5 seconds of completing step 3
above:
l
To program memory button 1 or 2,
press and hold the button until a
beep sound is heard.
l
To program a key, press and hold
the key
switch until a beep sound
is heard.
Adjusting a programmed position
(Programming to a button on the seat
side)
1. While the vehicle is stopped, press the
programming button for the seat
position you want to call up (button 1
or 2).
2. A beep sound is heard when the seat
position adjustment is completed.
NOTE
l
If seat movement is not required, only the
beep sounds.
l
When the ignition is switched ON, the seat
position memory function does not operate
unless the selector lever is in the P position
(Automatic transaxle) or the parking brake
is applied (Manual transaxle).
l
When the ignition is switched OFF, the seat
position memory function is operable while
the selector lever is in a position other than
P position (Automatic transaxle) or the
parking brake is not applied (Manual
transaxle), however, if the ignition is
switched ON while the seat position
memory function is operating, the operation
is stopped.
l
The seat position adjustment is canceled in
the following cases:
l
Any of the seat adjustment switches is
operated.
l
The SET button is pressed.
l
Programming button 1 or 2 is pressed.
l
The key lock switch or unlock switch is
operated.
l
The vehicle starts moving.
(When programming to the key)
1. Unlock the doors by pressing a request
switch or the key
switch.
2. After unlocking the doors, the seat
position adjustment begins within 40
seconds of opening the driver's door,
and a beep sounds when the operation
is finished.
Essential SafetyEquipment
Seats
2-9
Mazda6_8DL2-EA-13F_Edition1 Page21
Monday, June 10 2013 3:51 PM
Form No.8DL2-EA-13F