Filter
Top Products
Black plate (200,1)
Continue to press and hold the HomeLink
button while you press and release ―
every two seconds (“cycle”) your hand-
held transmitter until the frequency signal
has successfully been accepted by
HomeLink. (The indicator light will flash
slowly and then rapidly.)
Proceed with “Programming” step 3 to
complete.
qOperating the HomeLink System
Press the programmed HomeLink button
to operate a programmed device. The
code will continue being transmitted for a
maximum of 20 seconds.
qReprogramming the HomeLink
system
To program a device to HomeLink using a
HomeLink button previously trained,
follow these steps:
1. Press and hold the desired HomeLink
button. DO NOT release the button.
2. The indicator light will begin to flash
after 20 seconds. Without releasing the
HomeLink button, proceed with
“Programming” - step 1.
qErasing Programmed HomeLink
Buttons
To erase the existing programming from
all three operating channels, press and
hold the two outside buttons (
, )
on the auto-dimming mirror until the
HomeLink indicator light begins to flash
after approximately 10 seconds.
Verif y that the programming has been
erased when you resell the vehicle.
4-78
When Driving
Switches and Controls
Mazda6_8DL2-EA-13F_Edition1 Page200
Monday, June 10 2013 3:53 PM
Form No.8DL2-EA-13F