Filter
Top Products
RVS-DX, Digital Soft Starter Instruction Manual—4/01/04
6-9
(1) The FLC of the RVS-DX is pre-determined by the size of the power section. This setting can be adjusted
lower, but not higher than the unit’s rating. The Motor FLA setting is shown in amps. The default value will
be matched to the FLC of the RVS-DX value, and can be modified from 50-100% of the FLC value.
(2) Access to these parameters is available when dip switch 1.2 is ON.
(3) The setting in parenthesis is the maximum setting of that parameter when the WIDER PARAMETERS is set
to enable.
STATISTICAL DATA
Parameter Description/Function Default Value Range Access
LAST STRT PERIOD
LAST START MAX-I
TOTAL RUN TIME
TOTAL # OF START
LAST TRIP
TRIP CURRENT
TOTAL # OF TRIPS
PREVIOUS TRIP -1
PREVIOUS TRIP -2
PREVIOUS TRIP -3
PREVIOUS TRIP -4
PREVIOUS TRIP -5
PREVIOUS TRIP -6
PREVIOUS TRIP -7
PREVIOUS TRIP -8
PREVIOUS TRIP -9
Displays the last starting time in seconds
Displays the maximum current during last start
Displays the motor’s hour counter since commencement or
“Statistical Data” was reset.
Displays total number of starts since commissioning or
Statistical Data was reset
Describes the last fault
Displays the current at the last fault
Displays the total number trips since commencement or
“Statistical Data” was reset.
Describes the second last fault
Describes the third last fault
Describes the fourth last fault
Describes the fifth last faul
Descries the sixth last fault
Describes the seventh last fault
Describes the eight last fault
Describes the ninth last fault
Describes the tenth last fault
NO DATA
NO DATA
0 HOURS
0
NO DATA
0% of FLA
0
NO DATA
NO DATA
NO DATA
NO DATA
NO DATA
NO DATA
NO DATA
NO DATA
NO DATA
user
user
user
user
user
user
user
user
user
user
user
user
user
user
user
user