Filter
Top Products
42
Memory card compartment with a 16 MB MMC card installed.
To remove an MMC
1. Open the card compartment door by unscrewing the thumb screw.
The screw should only be finger tight. If it was over-tightened, use a
thumbnail, a coin or a screwdriver to open the door.
2. Just press a finger against the label of the MMC and drag it from the
slot.
3. Close the compartment door and fasten the thumb screw finger tight.
To add an MMC or SD Card
1. Open the card compartment door.
2. Grasp the bottom of the MMC and push the top of the card into the
slot. Once the card is started, use your fingernails to slide it the rest of
the way to the left, until it is firmly seated in the slot.
3. Close the compartment door and fasten the thumb screw finger tight.
Other Accessories
LMS-332 and LMS-337CDF accessories include MMC cards, MMC card
readers and MapCreate™ 6 mapping software for your computer. MMC
card readers are available in USB and parallel port versions.
Two switch boxes are available for this unit. The SB-7X transducer
switch box switches two transducers to one sonar unit. The SB-8X trans-
ducer switch box switches two sonar units to one transducer.
If these accessories are not available from your dealer, see the acces-
sory ordering information on the inside back cover of this manual. Visit
our web site for a complete listing of all the available accessories.
Insert card face up,
this way
Thumb
screw
MMC groove for card removal