Filter
Top Products
92
At left, Main Menu with Sonar Setup command selected. Center, sub-
menu with Sonar Simulator command selected. At right, Sonar Simu-
lator menu, with simulator turned off (check box is unchecked).
NOTE:
With Simulate Position checked, the simulator will automatically run
the GPS simulator (if GPS data was recorded with the sonar log).
2. To use the default sonar chart log stored in the unit, press
ENT|EXIT.
The recorded chart begins scrolling across the screen, just as if you
were on the water.
3. Turn off Sonar Simulator by pressing
MENU|MENU|↓ to SONAR
SETUP|ENT|↓ to SONAR SIMULATOR|ENT|ENT|EXIT.
Sonar Page, playing a recorded sonar chart in Sonar Simulator mode.
Tip:
The Sonar Simulator can use sonar charts that you or a friend have
recorded (logged) on a MMC card. (To see how, read the entry in
this section on Log Sonar Chart Data.) To play back your own sonar
chart, make sure the MMC containing the chart is installed, then:
"Play"
symbol
flashing
Title bar with
chart file name