Lowrance electronic LMS 335C DF GPS Receiver User Manual


 
63
Sonar Alarms menu with Fish Alarm selected. The check box to the left
is blank, indicating the alarm is turned off.
To turn the fish alarm on:
1. Press MENU|MENU| to ALARMS|ENT| to SONAR ALARMS|ENT.
2. Press to
FISH ALARM|ENT|EXIT|EXIT|EXIT.
3. To turn off the alarm, press
MENU|MENU| to ALARMS|ENT| to
SONAR ALARMS|ENT| to FISH ALARM|ENT|EXIT|EXIT|EXIT.
Calibrate Speed
The speed sensor can be calibrated to compensate for inaccuracies. Be-
fore you change the setting, first calculate the percentage that the
speed is off. You will enter this percentage in a moment.
For example, if you figure the sensor is reading 10 percent faster than
actual speed, you will enter – 10 in the calibration window. If the sen-
sor is reading 5 percent slower than true speed, you will enter + 5 in
the window.
A good way to gauge your speed sensor's performance is to compare its
reading with the ground speed measured by your unit's GPS functions.
When you make a run to compare GPS ground speed to speed sensor
speed, perform your test in relatively calm water free of current, if pos-
sible. (Unless, of course, you are taking the current speed into consid-
eration when making your calculation.) After you have a correction fig-
ure, here's how to enter it:
1. Press
MENU|MENU| to SONAR SETUP|ENT| to CALIBRATE WATER
SPEED|ENT.
2. Enter the number you calculated earlier: press or to change the
first character (+ or –), then press to move the cursor to the next
number and repeat until the percentage is correct, then press
EXIT.