Lowrance electronic LMS 335C DF GPS Receiver User Manual


 
119
4. Press to
LONGITUDE|ENT. Enter the longitude by pressing or to
change the first character, then press to the next character and repeat
until the longitude is correct. Press
ENT, then EXIT|EXIT to return to the
previous page display. The waypoint is saved and automatically given a
name with a sequential number, such as "waypoint 001." The waypoint
symbol and number appear on the map and in the waypoint list.
Navigate To a Waypoint
You can select any waypoint visible on the Map Page with the cursor,
then use the Navigate to Cursor command (we'll describe how later in
this section.) However, you can avoid scrolling the map to pick your
waypoint if you use the Find Waypoint commands:
1. Press
WPT| to MY WAYPOINTS|ENT. To look up the nearest waypoint,
press to
NEAREST|ENT; or, to look by name (and scroll through the en-
tire waypoint list), press
ENT. For this example, look by name.
2. If your waypoint list is a long one, you can spell out the waypoint name
in the
FIND BY NAME box to search for it. (Press or to change the first
character, then press to move the cursor to the next character and re-
peat until the name is correct, then press
ENT to jump to the list below.)
3. If the list is short, you can jump directly to the
FIND IN LIST box by
pressing
ENT. Use or to select the waypoint name, press ENT and the
waypoint information screen appears with the
GO TO command selected.
4. To begin navigating to the waypoint, press
ENT.
Navigation Page, navigating toward waypoint 001 and leaving a trail.
Waypoint
Destination
name
Trail line
(magenta)
Course line
(red)
Off course
range, set at
0.15 mile