Lowrance electronic Pro GPS Receiver User Manual


 
66
For connectors and wiring information for another device, consult the
factory; phone numbers are in the back of this manual. To set Com Port
Configuration:
1. Press
MENU|MENU| to SYSTEM SETUP|ENT.
2. Press to
COM PORT|ENT.
Configure DGPS
This unit will recognize Starlink
, Magnavox
and Lowrance DGPS
receivers.
1. Press
MENU|MENU| to SYSTEM SETUP|ENT.
2. Press to
COM PORT|ENT| to CONFIGURE DGPS|ENT.
3. Press
ENT, then use to enter the station frequency, then
press
ENT.
4. Press to
BIT RATE|ENT then use to select the station bit rate,
then press
ENT.
5. A. If you are not using a Starlink DGPS receiver, press
EXIT|EXIT|EXIT|EXIT to return to the previous page.
B. If you are using a Starlink DGPS receiver, press to
AUTO TUNING|
ENT. Press EXIT|EXIT|EXIT|EXIT to return to the previous page.
Configure NMEA
You can configure the unit to use specific NMEA sentences.
1. Press
MENU|MENU| to SYSTEM SETUP|ENT.
2. Press to
COM PORT|ENT| to CONFIGURE NMEA|ENT.
3. A menu appears showing the prefixes of the available NMEA sen-
tences. A check mark next to a prefix means the prefix is in use. Use
to select a prefix, then press
ENT to turn off the prefix. (Press
ENT again to check the box and turn a prefix on.)