Filter
Top Products
39
2. The Transfer My Data menu includes a message which tells you if an
MMC is present or not. If no MMC is present, you must first insert a
card into iFINDER in order to activate the Load or Save commands.
To transfer data from iFINDER to the MMC: press
ENT (for SAVE.)
To transfer data from the MMC to iFINDER: press → to
LOAD|ENT.
3. Saving: To accept the default name "Data" for the GPS Data File,
press ↓ to
SAVE|ENT. If you wish to rename the file (as in the example
below), press
ENT to activate the selection box. Press ↑ or ↓ to change
the first character, then press → to the next character and repeat until
the name is correct. Then, press
ENT|↓ to SAVE|ENT.
The unit will display first a progress then a completion message when
the data transfer is finished. To return to the Page view, press
EXIT|EXIT.
From left to right, these figures show the menu sequence for naming
and saving a GPS Data File from an MMC into iFINDER's memory.
4. Loading: There may be more than one GPS Data File (*.USR) on the
card. To select a file, press
ENT to activate the selection box, use ↓ or ↑
to highlight the file, then press
ENT to accept the selection. Next, press
↓ to
LOAD|ENT. The unit will display a completion message when the
data transfer is finished. To return to the Page view, press
EXIT|EXIT.