Filter
Top Products
6
After drilling the holes, pass the o-ring over the antenna cable and press
it into the groove on the bottom of the antenna housing. Now attach the
antenna to the mounting surface, using 4mm screws and the supplied
lock washers. Route the cable to the GlobalNav 310 and the antenna
installation is finished.
Magnet Mount
A magnet lets you temporarily mount the antenna on any ferrous metal
surface. (such as a car) To use the magnet, simply epoxy it to the bottom
of the antenna, using the epoxy supplied with your GlobalNav 310. Care-
fully follow the instructions on the epoxy package and apply it to the
magnet. Then carefully press the magnet to the bottom of the antenna
housing. After the epoxy cures (in about 30 minutes), the antenna is
ready for use.
MAGNET
Pole Mount
The antenna attaches to the pole mount
adapter with the supplied 4 mm screws. You
can route the antenna cable through the
slot in the side of the antenna, or pass it
down through the pole mount adapter. A
slot next to the threads in the pole mount
adapter places the cable next to the pole
where it can be easily routed down the pole
to the GlobalNav 310. The threads on the
pole mount adapter accept a standard
marine antenna mount.
POLE MOUNT