Filter
Top Products
1
2
3
4
5
5
5
6
7
4-3E
Clamp the engine using a vice
– Clean the engine thoroughly prior to disassembling.
– The engine can be clamped with a vice, using a protective pad to
clamp the lower rear bracket (see photo).
Drain the transmission oil
– Remove the transmission oil drain plug 1 including the sealing ring
and allow transmission oil to drain.
– Mount the transmission oil drain plug with new sealing ring and
tighten to 15 Nm (11 ft.lb).
.
Remove water hose, intake flange and ignition coil
– Loosen hose clamps and remove water hose 2 (only LC-engine).
– Pull plug
3 from the ignition coil, disconnect spark plug cap from
the spark plug.
– Loosen 4 bolts on the intake flange
4. Remove the ignition coil with
bracket, intake flange and reed valve housing.
– Remove spark plug.
.
Remove ignition cover and pump.
– Loosen bolt 5 and remove ignition cover.
NOTE:
– The water pump
6 is located on the ignition cover of the LC-engine.
– The ignition cover is centered with 2 dowels. They usually stay in the
engine case and should be removed with a suitable wrench.
NOTE: water pump shafts from the 2004 model have a hole containing
a spring
7.